10-02-2026, 06:48 PM
If the alignment is correct when it leaves the shop but the Mustang starts pulling again after a few weeks, I would definitely look for a worn suspension or steering component rather than continuing to adjust the alignment.
The inner-edge front tyre wear is an important clue. On a Mustang, I would have the front suspension checked for play in the tie rod ends, ball joints, control arm bushings, and other mounting points. A worn bushing can allow the wheel to move slightly under braking, acceleration, or cornering, which can change the alignment while the car is being driven.
I would also ask the workshop to check the wheel bearing, steering components, shock absorbers, and any bent or damaged suspension parts. Even a small amount of movement in a component can make an alignment difficult to maintain. If the car has ever hit a pothole or kerb, I would mention that during the inspection as well.
One thing I would avoid is simply doing another alignment without finding the cause. If a mechanical component is allowing the suspension geometry to move, the alignment machine can show good numbers while the vehicle is sitting in the workshop, but those angles can change once the car is back on the road.
A proper suspension diagnosis should include a physical inspection for looseness, checking bushings under load, inspecting the steering linkage, comparing both sides of the suspension, and looking at the tyre wear pattern. After any worn component is repaired or replaced, the car should then be aligned and the alignment results kept for comparison.
This type of issue is not limited to Mustangs either. Pulling, uneven tyre wear, knocking noises, and alignment that will not stay consistent can all point toward suspension or steering components that need inspection.
I would diagnose the suspension first and align the car afterward rather than treating the alignment itself as the repair.
The inner-edge front tyre wear is an important clue. On a Mustang, I would have the front suspension checked for play in the tie rod ends, ball joints, control arm bushings, and other mounting points. A worn bushing can allow the wheel to move slightly under braking, acceleration, or cornering, which can change the alignment while the car is being driven.
I would also ask the workshop to check the wheel bearing, steering components, shock absorbers, and any bent or damaged suspension parts. Even a small amount of movement in a component can make an alignment difficult to maintain. If the car has ever hit a pothole or kerb, I would mention that during the inspection as well.
One thing I would avoid is simply doing another alignment without finding the cause. If a mechanical component is allowing the suspension geometry to move, the alignment machine can show good numbers while the vehicle is sitting in the workshop, but those angles can change once the car is back on the road.
A proper suspension diagnosis should include a physical inspection for looseness, checking bushings under load, inspecting the steering linkage, comparing both sides of the suspension, and looking at the tyre wear pattern. After any worn component is repaired or replaced, the car should then be aligned and the alignment results kept for comparison.
This type of issue is not limited to Mustangs either. Pulling, uneven tyre wear, knocking noises, and alignment that will not stay consistent can all point toward suspension or steering components that need inspection.
I would diagnose the suspension first and align the car afterward rather than treating the alignment itself as the repair.

